Recent content by novedist

Incoder strip It just go's in a U shaped part. I pulled it down and let it go in the U then I cleaned the incoder strip.

I buy a syringe from Tractor supply and stick the needle in and draw it out where the printer gets it from.

Did you read my thread about error 068? It is under thread Ink not original. http://signs101.com/forums/showthread.php?p=702927&posted=1#post702927 I cleaned the encoder strip on the rail but didn't notice that I moved it from between the censor behind the head.

Yes I am up and running. Hope I can get the head cleared up from setting to long.

I found out what happened, the encoder strip slipped behind the censer. I don't know what happened but I must have pulled it out without knowing.

I already tried that, the head is still held in the carriage. It moves to the right instead of the left.

I replaced the ink with new ones and they are original now. The new cards that mutoh sent only half of them worked. After installing them I am getting error 068 cr. The print head doesn't seem to release. I didn't do anything with that. Recheck all connections and there ok. The printer...

I have replaced the smart cards many times. I am going to order new cartridges even though I have tried others.

Well I finely received all the parts that I needed. I replaced heater junction board, heater control board,Ink board id assembly and motherboard that I had and also replaced ink cartridge. Replaced new cards supplied by Mutoh still all cartridge read ink not original. I don't know what else to...

Another week go's by with no part. The part is DG-40135 heater junction board

That is the part that is on backorder.

Firmware is 118 sub controller 112 The part that I think I need is the board that the ink censon plugs into. All the cartrages went to that state at the same time.

Mutoh ink

My sn is 12 on a 1204. The part was ordered through Gregory. I contacted Jenefer and was told that they didn't know when the part would be in. I import tools and I know exactly when it will be in but not when it will clear customs. I am the service tec on this printer.

Firmware was upgraded and nothing