• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by NZ Mike

  1. Need Help JFX200 UV Lamp Temp High

    Problem just started, screen says UV LAMP TEMP . H IGH. Advise from the manual says "Wait for a while until the temperature lowers and the message disappears." What a gem! any one else having this issue, eventually the machine stops at ERROR 711LED OVH" And again we go to the manual to read...

  2. Overspray Problem

    Hmmmm Not what I wanted to hear, but thought it was comming. Down here in New Zealand its not so easy to get these things repaired. Whiat I have tried is entering difrent head id numbers and had some success in reducing the over spray quite a bit (ok for cash for trash jobs, but not quite there...

  3. Overspray Problem

    One more thing The overspray is relative to the firing direction. If bi directional,over spray is on both side of the image, if uni then only on the left side of the print.

  4. Overspray Problem

    Mimaki JV3 160sp bad overspray from the cyan. I have tried so far: Static control tests = no change New Cables (slider board to head) = No Change damper swap = same head over spraying with diffrent color (was expected) Thought I had it untill I tried: Cable swap (m slider board to c head /...
See more
Top