Recent content by Paul R

OK, then Thanks for the correction. I was thinking of eco-solvent cartridges.

This has been driving me nuts for all of twenty minutes. I went down the internet rabbit hole and found a slideshow of humorous custom shower curtains that were digitally printed. This intrigued me, as it can potentially grow into an extra revenue stream, properly handled. But all research I...

This is common When this happens, it is usually because the chip in the kit is bad or out of date. Contact the manufacturer of the kit and give them the what for. If you don't, this will continue to happen to all of us.

I hear what you're saying But it seems to me the main problem that the asker needs addressed would be solved with backing paper. With a roll of wider paper, no laminate will hit the rollers at all.

Thanks. I'll print a swatch from your recipe. It was an attempt to match the powder coated shiny-*** black from the client's trailer, or as close as possible. I'll figure it out. I do know it's possible, but Mutoh is bumming me out.

sigh After 21 years of graphic design in the newspaper industry, I answered the cry for help from a friend's widow. Three months later, I am only starting to mount the learning curve. I don't have any advice to offer, naturally, but had to respond since I identify strongly with the phrase you...

Use craft paper backing Like someone else here stated, if you use craft paper backing that is wider than your laminate, you don't have a problem. I laminate 54" materials with 54" laminate on 55" craft paper. Skew doesn't matter too much in that case, unless you are laminating over 20 feet...

I'm trying to print a 6 foot long piece with a 4 color black background, but keep getting streaks in the black. I managed to get one decent print, but have burned 18 feet of IJ 35-C in the process and still need another print. The magenta and black inks were both low, but I don't think that...