Recent content by Print Com

I'm not sure if, what is in pic is wrong. But I can't seem to get plotter to read sheet size. It will will read the pinch rollers and assuming its reading the width. When it gets to the length. It will read the top of the page (head). Then when it goes to read the tail (bottom) of page. The...

I have a mimaki cg-160 fx plotter. The plotter was running fine and every so often more time now. Plotter would read the head of the sheet then as it goes toward the back it cant read it. I think its the eye instead the plotter head. I circled what I think it is. wanting to know how to set it...

I tried putting matte lam over the registration marks and still no go..went as far as putting premask over it to and drawing making marks and still no go..can anybody help me with this problem. Thanks

Thanks.. I didn't even think about that. Will try Monday.

I am printing on oracal reflective material using a hp design jet L28500 printer and mimaki fx160cg plotter. My question is I'm not having trouble printing on reflective, but having trouble plotting it using illustrator fine cut. When I get it printed and run through the steps to read the...

can anybody tell me what this font is.. Thanks in advance

I am running production house 10.2. Now sure what you mean by color correction? Where would I do that at? In production house or photoshop? Thanks

here is what mine outputs out... The Tyler type is cut vinyl in gold leaf..don't look at that by the way. I have a profile for it from the manufacturer. Just not sure whats going on. any help would be great. Thanks

I have an HP L28500 laytex and was wanting to print off some graphics out of aurora graphics art. Tried printing off diamond plate, silver brush plate, punch engine turn to name a few. The colors don't look silver and some are not even close. I know my printer don't print metallic or silver...

Would be the dampners, manifold causing this. I would thought that would be caused by over ink. The print looks like its it's just out of register a lot. How can you tell if the dampners and manifold are bad. Thanks

I changed the encoder strip today an now I am getting this. Thought I fixed problem but I guess not. And it also is printing at a diagonal when I went to see if print heads were calibrated. Any help would be greatly appreciated. Thanks

I ran a test draw and the cyan is misfiring on a couple of nozzles, but everything else is perfect. oh, what do you mean by drop outs too. thanks

I found this, not sure if this is your problem, but you can check and rule it out. getting an error 30, what does that mean? An error 30 is a general operation error that normally point out something simple that might have been overlooked. This includes trying to do alignments while the...

LOL. yet another problem. I have a mimaki jv3 160. currently running production house 7. My question is when I run 4 pass bi. it seems like it runs good for awhile, then looks like it is starving for ink.If you look at pic. It almost looks like it went to 2 pass. I am not sure why this is. I...

Thanks for everybody that replied. I bought a encoder strip getting it ttoday. Thanks for the help