• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by SheddShirts33

  1. Roland Sp-300 Not Turning On

    Can you message me directly? I am not sure how to do it?

  2. Roland Sp-300 Not Turning On

    I had an electrician come and his best guess is the power board is bad because all the power works before it but then the 2nd half of the board basically has no power(very low amount) I also noticed the attached photo it looks off but maybe thats how it normally looks and isnt the issue. I...

  3. Roland Sp-300 Not Turning On

    I am having an electrician come tomorrow and see what he has to say and will report back Really appreciate all the help!

  4. Roland Sp-300 Not Turning On

    I assume I can just buy a power socket from roland? I am going to try and get an electrician to the shop and see where there is power

  5. Roland Sp-300 Not Turning On

    Sorry I did not see the previous message because it was on page 2 but correct nothing lights up anywhere on the back or the front

  6. Roland Sp-300 Not Turning On

    I put the old power board in and I can still hear the faint buzz noise but its alot quiter and sounds less powerful(if that makes any sense) When I unplug the power board and turn it on, I hear nothing... Any suggestions on if it might need a new something? Really hoping I can get this fixed...

  7. Roland Sp-300 Not Turning On

    So unplug the power board, plug in the printer and then hit the on switch and hear if I hear the same faint buzz noise?

  8. Roland Sp-300 Not Turning On

    The circled item is what I replaced and it was a used one from ebay. Seems to act the same as the previous one

  9. Roland Sp-300 Not Turning On

    How would I test for that?

  10. Roland Sp-300 Not Turning On

    When I Put the black probe on the green yello wire and the red probe on the brown wire, I got a reading of 0 if i was doing it correctly. When I use the Non Contact AC Voltage detector in that area, I am getting a beeping like there is power there. Again I have never used these before but...

  11. Roland Sp-300 Not Turning On

    I just bought this volt reader so I really am even sure if I am using it correctly but In the attached picture the part I am touching is showing 7 Volts but the other part of it seems to not be getting any volts that I have circled if that makes sense. I have tried a cord from a different...

  12. Roland Sp-300 Not Turning On

    No lights are turning on. I will see what voltage I am getting from the power supply right now and report back. Thank you again!

  13. Roland Sp-300 Not Turning On

    I have attached a photo of where the power stops. I really am not sure and have no ideas and any help is appreciated. The red arrow is where the power stops. Thank you!

  14. Roland Sp-300 Not Turning On

    I have been searching this site for years and always get answers to problems I am having and finally making a post after about 13 years and hopefully someone can help me. My SP-300 would not turn on the other day when I got to the shop. Had the Roland tech come and said it was getting power...
See more
Top