I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
When cutting as the material comes out of the front it starts to buckel when it goes into the cloth basket....get creases in it...have to babysit the entire run as it cuts and goes back and forth.
It seems to be tracking fairly straight when we put it it....does it on sheet runs and roll runs...
Can anyone share a good method of removing 3M 8150 clear from windows that the product has only been up for two weeks ? It was used for a short promotional deal on five windows.
Any feedback is appreciated.
Install help needed...
I just got done trying to work with the same stupid premasked piece. A entire side of van on a body shop repair ,,graphics sent to us from a company out of Indiana....50" x 110"....Chev van and it turned out terrible....it tore, ton's of small bubbles after we peeled the...
Job Done
Well we did it...never never will we do another one that is premasked....it was 3m controltac r/a...but you can't see how it is turning out while your appling and you can't lift it up with out it tearing and the air release part does not perform like a normal wrap with laminate...this...
Thanks
Thanks for the responses.....we are lucky that its a Chev van and only the drivers side....yes on the extra charge.....the sales rep of the producer of the graphics wasn't to helpful.....oh, well !!!! A lesson learned on what to do when we receive such a product and also learned to ask...
Any one out there ever install a premasked, no lamination horizontal 3M ControlTac no lamination ? Got graphics from another shop out of state to install on van ....
For Sale...Roland SP 300 with Wasatch SoftRIP.....cloth media baskets front & rear, complete set of new ink cartridges and new black head replaced in January2015. Price includes 30" Daige cold laminator.
Upgraded to larger printer and laminator.
Located in South St.Paul, MN ...buyer responsible...
We have major issues with the SP 300 on the cutline being off by up to a half of inch ....any suggestions ? The printer is 13 years old....we are using Flexi rip.....
Currently have a Roland 30"...looking at upgrading.... looking at a Mutoh 1324 54" printer...any feedback on the unit positive or negative..any help would be appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.