• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

signheremd's latest activity

  •
    signheremd reacted to kcollinsdesign's post in the thread Need ideas for trailer design with Agree Agree.
    I know the feeling. Every so often the well is just dry. Without being preachy, here are some rules I follow: •Don't be so literal. the...
  •
    signheremd replied to the thread Cutting is off slightly.
    if you set the print and cut up in Flexi and add the marks, and then print in Versaworks, you put the print in the Graphtec and...
  • signheremd reacted to MarkSnelling's post in the thread Vinyl Recommendation with Agree Agree.
    I can't entirely disagree with you, but I see people run right to cast films when concerned about adhesion or durability. While you...
  • signheremd replied to the thread Vinyl Recommendation.
    Any good cast vinyl. If printing I would recommend: Avery MPI1105, OraFol 3951RA, or any other air release cast vinyl with strong...
  • signheremd replied to the thread Question Ricoh GEN5.
    Sounds like air in the head. You should have a bleed line for each head with which you can uncap the line, aim it down into the waste...
  • signheremd replied to the thread Aluminum Composite vs Aluminum vs Alumalite ??.
    Yes, free standing or attached to a post the wind can bend these. I would use 080 Aluminum or 1/2' MDO Plywood as a base in this case
  • signheremd replied to the thread Amazing Employees.
    Good people don't cost you money, they make you money. You have to pay him more to keep him, otherwise you perpetually start and train...
Show older items
Top