Recent content by tbullo

Yes, motor just wouldn't engage. Wasn't receiving the 24volts. But it beeped, and you could here the switch activating.

It could be a switch on the pcb board. There are 2 of them (blue rectangle), 1 for forward and 1 for reverse. Take back cover off and you will see the board. You can hear (and feel) them engage when you press the button. I'd check that first. I just got my board back from being repaired from...

Maybe? https://fossilgraphics.com/hardware/npstraditional/

https://www.designandmake.com/ has some good stuff, but not that one in the pic.

Cutting Master 3 is on the Graphtec site. Go to support then Legacy software https://www.graphtecamerica.com/software

Maybe see if Data sorting is on.

I'm sure that I'm in a small minority, but i use Cadlink ProfileLab. I use signlab and it works just like that and was easy for me to pick up. It's not cheap, but i think they will give you a free trial.

OMG, I think I've watched all your videos on Youtube over the years. Welcome

Thanks. Just looked into their catalog and didn't see anything like this. It's that dovetail running down the back and pressure fit of a .25 acrylic piece that throwing me off.

Seeing if this is a still available sign system. Tried google lens, but no good results.

You prob. already checked, but sometimes i bump that E stop on the back of mine.

We have used CAB signs with good results. Turn around time was decent.

I think PPG owns 1 shot. Ronan has it's 1 stroke lettering enamel. Here a picture of a can i received about a month ago. Some of my other cans have A Spraylat company, but they are years old.

We like to use Rowmark stock applied to the PVC then route. Lots of brushed finishes to pick from.