I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We've run UltraFlex UltraPoplin S240 on our 360 for years, but always have to tape it to the TUR. It will never advance properly without it. You'd have to run a fabric that's heavily coated in order to do what you're trying to do. At that point, you'd be running canvas, and lose the softer hand...
Based on all of this information, it sounds like it would be quite an investment on our part. If we're contracted to produce 500-2,000 of these per day I think we could justify the machinery depending on the cost. If I were to paraphrase James Burke and look for the right machine, I'd be...
Good feedback - would the thickness of the metal give us some more clues? It's only .009" thick. Most of the videos I've seen of sheet metal hemming are with much thicker product, that does indeed need initial forming operations.
I'm looking for suggestions on equipment needed to take a printed sheet of .009" sheet metal and bend the perimeter edge over 180 degrees onto the back for safe edges. This is a decorative consumer product that we are looking for even the terminology of what this type of bend is called and the...
We had our Digitech Trufire LT/X2 installed 2 weeks ago and we're extremely happy with it. We're running corrugated cardboard and coroplast at 2pass and 3pass. 4x8 sheet in 0:23 seconds at 2pass and 0:36 seconds at 3pass. We're blown away with the speed, simplicity, and robust construction of...
I can’t remember what type of encoder is on the 10000 but it sounds like it needs to be cleaned. If it is a metal strip across the width of the platen, carefully cleaning it with a lint free poly wipe with alcohol would do the trick.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.