Recent content by trafficbarriersolutions

We have decided to hold off on it for now, it turns out the lines go out once we put everything on the surface. It is about $700.00 to have replacement. But eventually we will get a new roller. The part number is: CS-MF-UN-ROLLER from Sign-In-Global...

I just got a response from Sign-In-Global. They do offer replacement rollers. Which is good news!

I do understand that! The top roller of the laminator is fragile enough to cause permanent damage. We are one of many companies who used our laminator like this. Unfortunately, it was the wrong way to cut the laminate off.

We all have learned our lesson on using sharp objects on the top rubber roller is a hazard of damage. However, I found an alternative to cutting without damaging the roller. Avery Dennison has a Snitty Vinyl Cutting Knife where the blade holder snaps on the laminate with a plastic bottom to...

Hi, I have a Qomolangma FMJ-1600-WA-PLUS. We had this laminator back in December 2023. We ordered it off Amazon. It seems as though all of our employees have made scratches and dents from using box cutter blades. Unfortunately, these cuts are causing bubbles in our laminating. We didn't know...

Here is what the colors look like when printing a Batch Automatic Correction. The last four colors look lighter than expected. And it is based on the output from VersaWorks.

No. Do I have to shake the pouches? Will this change the outcome of the colors to exactly what I need?

The nozzles look fine. The printer is printing lighter colors than what it is intended.

I have had this printer since May 2023 and has not had problems printing correct colors until recently. I have a Roland TrueVis VG3-540 and use VersaWorks to print my materials. When I use Flexi to print from my Roland Printer, it prints darker colors, but when I print from VersaWorks, it prints...

I have figured out how to connect them. Select the entire exported lines that were from Flexi. Go to Transform Tab, then go to Contour Operations, then click Merge Selection. Can also right click the selection and click Merge Selection.

That helps me a lot! You're extremely helpful and I truly appreciate you so much:)! I am possible going to see what my boss says about getting humidifiers for the sign shop. It makes sense to not only keep the room temperature correct but also room moisturized with a humidifier so that the...

The room is getting Torpedo Heaters since the building is too large for a Unit and would cost so much to install a unit. And the walls will be sealed completely keeping the sign shop office heated in the wintertime and putting Air Conditioners to exit to the warehouse of the Sign Shop when...

I don't think he did. I'll have to call my dealer and see what to do.

My Roland TrueVis VG3 540 is now printing these little holes of unprinted spots. I have been trying make some color test prints to match a color for my Chrome material. It never started doing this until now. The picture has the one recently printed with unprinted spots of holds and the top ones...

I know that feature but very hardly do I use the middle rollers. The 2 outer rollers are pressing down too hard on the material causing it to wrinkle.