• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by VNG1

  1. Mimaki JFX 200 - LUS 150 : I need someones coro profile for ONYX. Speed is too slow. I need a faster Profile

    No it is a 2 Head, JFX200. I know the rasterlink might have one but I am trying to find an ONYX profile for Onyx since Onyx seems to be much better than that Joke of Rasterlink. And no I am not looking for something to tear through it in bulk, Just at a speed like you mentioned, 7-9 Minutes...

  2. Mimaki JFX 200 - LUS 150 : I need someones coro profile for ONYX. Speed is too slow. I need a faster Profile

    So I recently got this Mimaki JFX 200. Prints great, I have it with Onyx now just like all my other printers. However the profiles you can get from Onyx are limited, I get like one mode for every substrate. It takes about 14-15 Minutes for a full sheet, I have seen people with 8-10 minute...
    • VNG1
    • Thread
    • #mimaki #jfx200 #onyx
    • Replies: 3
    • Forum: Mimaki

  3. JFX EX + LUS120 and coro boards

    Hey Kdean, I need your help! Can you share your Coro profile with me ? I also have a JFX 200 and my 4x8 Sheets are taking 15 min each, I want to have another mode/profile. That can run at your speed as well, Please reach out if you can share that profile with me ; angel@intenseink.com
See more
Top