Recent content by xboxhacker

Thanks reQ! got it!

I need a few new dampers for my JV3. I have "large" ones now. But i see there are smaller ones too. I don't really plan on printing tons of stuff. So whats the difference? Thanks!

I was just searching digikey for some! LOL Your right, no room at all.

With this printer, yes. With electronics, no. I have been working with board level design/manufacturing/repair for almost 20 years. Including SMD and BGA repair. Nothing ventured, nothing gained! It only cost $500 :Big Laugh Turns out one pin in the data cable had bent back over itself. Took...

Good call!!! I went back and double checked the ribbons on the MB. I reseated them. NOW WE ARE PRINTING!!! BUT......yellow and cyan seem to be printing alllllll the time. Check out the image. They both a spitting out ink as it leaves the home position....and all the way back. UPDATE...

here is something i forgot to mention.... LOL After getting the MB running, and after trying the first test draw, i did a few custody cleans. About 5 mins each, did about 3. Tried a test draw. The black started printing. Only about 20%. Nothing else printed. So i thought i would do another...

Yes, took a syringe to the cap drain lines. I WAS able to pull ink. Also, i can see the caps drain when i did a disway.

So we will start with a little back story on my printer and me :) I bought this printer form a guy on craigslist for $500 with extras...thought i did ok. The machine had a Error 7 (----**--) The first thing did was to try a data swap. No good. Then i tired a extra head that came with it. No...