Recent content by YSP Mario

Hi, Cutting strip part No. 391-386 check if is damaged on cutting line. Before new knife installing check knife holder and spray it with WD40 but then clean it very well with compressed air to be sure is without grease and dust. M

Hi, I think everything is OK with Summa, you need to check knife holder and clean it. And hope you know that for thick sandblasting films you need to buy special 55 degree knife with 0,5 offset (Summa part number 391-358). You can see on corners is not good rotation of knife and same curve has...

Thanks for reply So your answer is that is possible, but it must be done by specialist, I understand I actually asked if someone it done before action like this on Brother GTX printhead, because it is not only soldering problem, let say it is possible, but how to open printhead without damage etc.

Hi to all Has anyone here tried to solder a flat cable that connects the print head PCB and the print head? The flat cable connection is swollen, but the printhead is completely correct working before damaging the cable. At Brother Service they say a new head is needed, which is pointless, of...