Recent content by Ziyaad

No I haven't, Do I need to disconnect the connector 1st?

HI Damon, I've replaced the Heater control board that i got from Roland locally. They assured me they've tested the board before giving it to me, however the issue still exist, NO FAN,

To be hounest , I have a voltage meter, but not very knowledgeable on how to test voltage and stuff

Where about is that?

Our Local Roland tech said it's the servo board, in SA there is none available, so I got one from a Sp540v same as mine that a dude was breaking up

Servo board or Heater control board?

You mean firmware on?

The board came out of a SP540v that had issues with some issues, but apparently this board tested

I just replaced the heater control board that I got locally, still same issue, heater works perfectly though, it prints perfectly, but no fan/vacuum to keep material down:rolleyes:

What will the cost be and shipment to South Africa, Just a quick question, If the heater control board is blown, wont this effect the heater also? because my printer heats perfect.

Hi all All of a sudden when I got into office and wanting to print, I got a head knock followed by scan motor error 0080, after I switched the off, I got a noise that almost made me sh*t my pants and a smell of something burning, after inspecting the printer. I saw the servo board IC2 burned...