Search results

Do cap, waste pump and dampers. If that don't fix it, get a head. Yes, heads are expensive. No, the $200 ones from Indonesia are really a scam. Yes, I know they cost a lot. Yes, the ones with the cheaper, but it's a big hassle. Heads are consumables, replace the cheap stuff supporting them. If...

I have had really good luck with General Formulations GF 885AE RoughMark material for stuff like that. Not sure your preferred vendor, but I get it from Plastic Guy out of Kansas. Might try asking for a sample to see if it meets your needs. https://plasticguy1.com/products/ols/products/pg-588ae...

Modified ink and adhesive, modded printer as well to get the height required. Asides from the higher head gap and extra heads (4 6 channel TX800 heads), messed with the bidirectional calculations to adjust to higher pass counts. Also had to stack some more UV lamps in.

Here we go, full raised sign stuff. Need to tweak the ink a bit to keep the creep at bay. Printed to a transfer and applied to wood, not printed directly.

Feel free to DM me for specs. It's pretty easy and don't want to give away the game to early. But it can do lettering and whatever else.

Alignment can be tricky without a line to work with; these are printed raised transfers that are generated and printed on demand as opposed to being applied one letter at a time. The only thing being added to the sign or whatever is the dots themselves without extra vinyl/tape/etc. Not a...

Playing around with decent speed printable braille transfers that meet ADA compliance and can be done with a $3k printer. No flatbed needed, small foot printer using 3 dirt cheap XP600 heads. Nice thing is it lets me print huge gang sheets of the things where needed. Wondering if there is much...

If the smoke is purple, they have elected a new graphic designer.

Might be better to fill the lines with flush if you want to undo the bypass.

Happy to provide assistance remotely or even in person if needed. If you're mechanically inclined, remote is usually pretty easy. I also have a JFX200 and JFX200 EX in shop I can use for reference when guiding people over video if needed. Likewise, when on site, I also am more than happy to let...

Is there a way to do it? Sure. Would be through the command set. That said, would involve figuring out what all commands the LED drivers respond to and locating where they are in the ripped data stream, modifying said data and making sure RasterLink sends it to the printer without doing some...

Looking for an on-site tech, or someone to guide you through it remotely? Not a particularly hard process, just takes a good deal of time.

The driver board turns the lights on in zones. Jumping the lights on would do wonderful things like curing ink in the capping station.

On other Mimaki printers without the weight sensors, that is the way.

It is based on a weight sensor, so make sure the ink bottle can move freely if emptying it didn't fix it.

All the artists I know that work with that kind of stuff mostly do NSFW type art, knocks out a few people as it's a licensed/trademarked character. Then again, I don't think I have seen Casper nor a horse wearing any pants. Typically you find an artist by checking out their portfolio and...

The G version uses gloss ink. Can use whatever media you like. Gap sensor is NOT moveable so it sucks for round labels (unless you get black mark ones). Uses pigment ink.

Epson TM-C7500 series is what I use for that kind of stuff. Prints at about 1km/hr up to 4" wide.

The school fundraising stuff always makes me nervous, lots of companies leverage kids to sell things so their schools can make a few bucks. Usually ends up being a real bad deal for all but the company doing it.

If it says DATA REMAIN, have you checked to see if the printer is in remote mode?