Search results

or cut the damned thing into convenient bite sized chunks with the angle grinder. buy 3 orange cones at home depot and let the pieces fall where they may

the customer either pays for the rental or DECLINES and goes with someone else why not rent a piece of scaffolding? (or buy one on craigslist and stick it behind the garage?)

there was a time i would have killed for this guide. it looked so simple as i pulled it apart...

is there ACTUALLY a com1 on the laptop? it is rare these days to see a db9 connector most devices still have a com1 and com2 even if they are just phantom devices, and perhaps a header on the motherboard, deep in the laptop if you are using a usb to serial device, it would normally be com4 or...

it is also possible that reassembling it, you put the little rivets in the wrong hole. being off by less than an inch makes the ribbon "bunch up"

I know I shouldn’t be such a Luddite when it comes to software (I am a consultant, after all) but, my rule is that every upgrade disappoints in some way. I always say quickbooks 99 was the high point for intuit. (I am only joking when I say adobe hasn’t been the same since it stopped coming on...

We have nothing but good things to say about GRS. They are very helpful. My neighbor in our industrial park used them for years. (he switchEd from Mutoh to mimaki printers)

setup a webcam (or move one of the cameras on your security system for a few days. get a clip showing the scratches/goouges coming off the roll before it enters the printer

We love tyrell tech. We are about 50 minutes from their flemington nj office. Sometimes, there is a big difference between being down for 2-3 hrs & waiting til the next afternoon for a part.

Agreed!

My old Roland does something like that when I have to reseat the number 4 cartridge (only #4 flashes, until i Reseat it. Probably time to power down. unplug. WAIT 15 MINUTES (so we don’t make a problem that nobody can fix) carefully unseat & reseat everything you have touched so far. Reassemble...

the yellow band going across means that head is bad, or the cable (or of course that board) over the years 3 of my black heads have gone bad that way IT'S ALWAYS POSSIBLE one of the capacitors is leaky, or one of the small transistors further back is bad. if you actually removed the...

That answers my question. (What happened first?) REALLY CAREFULLY unplug head cables & be sure 1 foil isn’t folded over. isn’t there 1 cable on this machine that is different? (It has 1 foil More or less than the other?) it is possible one of the large transistors that power the heads has...

what caused you to replace the 2 heads in the first place?

we have bought EVERYTHING from one of the auction services or from a shop going out of business. several of my guys say i never buy anything under 700 lbs. (probably true if you say 300 lbs.) when i bought my mutoh hybrid, it came from dallas tx in a church basement. we are in nj. i did really...

why yes, i suppose it is

i was thinking i would register an .EDU domain & give everyone a complimentary email address

the solution would be don't upgrade

very true! i am incredibly cheap. i only purchase new when i am cornered with no way out. ebay gives the widest audience but i have purchased many pieces of equipment within as little as 20 miles. several pieces i didn't have any intention of purchasing until i saw the offering

(1) buy a service manual. (2) do A simple voltage check comparing the working channel to the bad ones there are 4 pairs of transistors. From collector of the npn to emitter of the pnp is approx 41 Vdc. on each pair there is 41 volts from center pin to center pin. IS IT PRESENT ON ALL 4? IF YES...