I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Cleaned rotary encoder disk and sensor and this seems to have worked. Not sure why it was only happening with one media (canvas) but I was able to get a nice print after the cleaning.
Thanks for all the suggestions.
I've attached a couple of images that show the banding issues I've been dealing with lately. It really shows up in green and blue saturated color. The banding is a pattern that will produce a good result for 1/4 to 1/2 inch then band for an inch or so then print a good result again. This pattern...
Thanks Stealth. I'm looking at a Rockhopper II manual Rev ;1,1, 08/03/2004. The only adjustment that I can see that would fix this is the Repeatability Adjustment (Bi-Directional/Uni-Directional. When I run these tests the lines look very close. Is this the test you were referring to or am I...
Rockhopper II 64", latest firmware.
I'm trying to tune my Mutoh printer to solve a banding issue. The banding is happening where black or a portion of black is in the image. In maintenance mode I ran the front and back and head slant patterns. Sure enough the black head was out of alignment. I...
It's been a couple of years since I switched my Mutoh Rockhopper II from mild solvent to Eco Ultra inks. I use Onyx PosterShop 7.3.2 and use ICC profiles for Eco Ultra inks. I'm happy with the switch, there's no problems however I have always noticed that my prints are more grainy than they were...
Solved....
It appears the noise was coming from one of the two fans that are on either side of the print head. I discovered this when in the administration panel and found a way to turn on the fans while the head was stationary. When running the fans are producing this noise.
TJ
solved....
It appears that I have fixed the problem with the banding issue. The problem was either the black print head, which I replaced, the PF adjustment that was out 1 mm or the encoder strip which was cleaned. I'm guessing the black print head was the main cause. So far the Mutoh is...
PF adjustment
I'll try this next but since I'm running the wave firmware on my Mutoh would a bad pf setting not show up as sine wave banding rather than the straight line banding issue I'm showing?
TJ
Mutoh Rockhopper II 64 running current firmware with wave.
Onyx PosterShop 7.3.2.16
Ultra Eco Mutoh Ink
Media - banding happens in all media, more visible in gloss media
Problem. Images that contain dark areas will show what looks like white bands. Lighter shaded areas will not show this...
Randya, I'll be lubricating the races today. The head does move smoothly but I haven't lubricated the races in quite a while. Thanks the the info.
This morning the noise is gone. I turned the printer off last night, came in this morning and started a job and no noise, but I am a day older...
An annoying high pitched noise started coming from my 4 year old Toucan LT 64 this morning. It appears to come from the print head as it prints. When the head is parked it does not make this noise. There's two fans, one on each side of the print head. I'm hoping it just one of those fans. Anyone...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.