• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1.

    GBC Artic Titan 165 - Stop doesn't work - Safety sensors don't work - any help?

    Thanks for the help! I had the main board fixed at a local electronics shop. NOW, the machine works good again, BUT the stop switch stays on. I have to hold down the run button or keep my foot on the foot peddle or machine just stops. The switch panel is new since I replaced that first trying to...

  3. Laminator gone crazy need help

    I had a similar problem. Replaced the control board with the speed controller on it and it solved the problem. Scott

  4. Need Help GBC Titan 1264 WF - Stuck on full speed

    What was the solution that you found? My machine has a similar issue...runs continually and you must turn main power switch off to get the rollers to stop turning. Thanks, Scott
  5.

    GBC Artic Titan 165 - Stop doesn't work - Safety sensors don't work - any help?

    I know this was posted long ago! But, my arctic titan has the exact same issue. What did you find was the problem/resolution? Thanks, Scott

  6. Gerber Sabre Quality Problem...Chatter?

    Tools Is Sharp! The collet and bit are fine. Today I routed a DiBond sign with a 1/2" circle in the center. The hole did not rout as a circle...it was a square-circle mixed shape?? I wonder if the Enroute software is dropping info when it sends the G-code to the Sabre router... I also get flat...

  7. Gerber Sabre Quality Problem...Chatter?

    We have a Gerber Sabre 408 router that has started to produce rough edges on routed pvc. We are using Enroute4. We have also noticed that the gantry is loose and we can move it by hand about a 1/16" in both directions when the table is idle. Has anyone had issues with "chatter" in the gantry...
Top