I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Got it!!!!
What I had to do was make sure that the black box around my images was 3 inches or more away from the left and right pinch roller. Also make sure that there was less than ten inches of white space in the front and six inches or so in the back. My problem was that I had my middle...
Ok, I am now preparing the file and sending it to print and cut through DX. it prints fine and everything looks ok. the job then goes to production manager and is put on hold for me to cut. I am going to check all the media sizes and make sure my white space is enough and not too much all around...
EPOS error
Thank you,
I have done all of that. the manual said between 3 and 10 inches of white space and to not let the box exceed the width of the rollers. I have left plenty of space and have straight cut media.
I also ran the alignment and it does fine.
However, the sensor recognizes...
I am using an Ultima SC-1400D cutter and Mutoh VJ 2606 printer with Flexi Print DX software.
I get the contour cut all set up in flexi and rip it into onyx. everything looks good. it prints fine and loads the cut job into production manager.
I load it into the cutter after printing and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.