• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Envision 375 Plotter Target Calibration

    Same issue. I have downloaded Envision_RevH.zip en started updating the firmware. After a couple of seconds it stops updating the firmware and then the Gerber Envision started beeping. The Envision stopt working since. Every time I start the envision it is beeping and the display only shows 2...
    • V1
    • Post #16
    • Forum: Gerber

  3. Gerber Edge Fx Horrible Noise

    When i turn the Gerber edge fx on, after about 10 seconds it starts to make a horrible noise. It lowers the slot were the foils go in and then it raises the slot until it slams into something. This makes the horrible noise because it tries to raise it even it is already on the top. This issues...
    • V1
    • Thread
    • Replies: 2
    • Forum: Gerber
  4.

    Need Help Alignment Issue Gerber Edge Fx

    Thank you! Now i can print without any gaps :)
  5.

    Need Help Alignment Issue Gerber Edge Fx

    Hello, I bought a gerber edge fx a couple of days ago. I am trying to figure out how everything works and made a couple of test prints, but I can’t get a 2 color print perfectly aligned. Every time it leaves a small cap at the side where the vinyl feeds in. (see attached picture) Is there a...
    • V1
    • Thread
    • Replies: 4
    • Forum: Gerber
  6. V

    none

    none
    • V1
    • Profile post
Top