Search results

Good! Glad your up and running.

Most people prefer USB setups due to the fact that both serial & parrallel are fading out. I would have to agree with Techman, using serial will give the cutter the ability to relay information back to the software, like obtaining the media setup from the cutter (POLL SIZE - is the term used in...

Thanks that is helpful information.

Whenever I want to put a finishing touch on a design I use the SMOOTH TOOL in AICS2. You simply select the tool and trace over the node area that you wish to smooth out and it really does a nice job without disturbing the bounding nodes. Try drawing some crooked node paths and try it out. It...

Everyone has to start somewhere, and I know when I got my start I was very blessed to have a couple of guys willing to answer my questions, and now I get to give that back. Feels good! Thanks again.

You can go here for quite a few QuickCut resources: http://www.signsupplystore.com/ProductCart/pc/viewPrd.asp?idcategory=0&idproduct=12552 But this will benefit you the most: http://www.ssksupport.com/Manuals/GraphtecSupport/SoftwareSupport_Graph.pdf

Anytime, glad I could assist. Best of luck to you Sir!

QuickCut QuickCut will not work with Corel X3. It will only work with earlier versions upto Corel 12.

Here Are SignSupplyStore.com's current packages.http://www.signsupplystore.com/ProductCart/pc/Large_Format_Vinyl_Cutters.asp Thank you JackPine for your kind words.

What software are you using?

I myself have had no reports from the field in the way of error. You can always roll back by installing the previous version until the issue is resolved. Get them here http://www.signsupplystore.com/productcart/pc/viewContent.asp?idpage=70

It does sound like an HP-GL/GP-GL issue. That particular model is a bit before my time, and I have had no exposure to the model, but if it has a control panel try and access the COMMAND options and verify that the cutter is in HP-GL mode. You might even try to perform a NOV RAM (unit reset) to...