I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Main Board
Thank you for the reply. I think I found the problem - on my main board there is a cable detached from the board. I would have to figure this is my issue.
Main Board
Thank you for your reply. I noticed after inspecting closer that on the main board there was a cable that was detached CN11 - Im pretty positive this is the culprit. It needs to be soldered back on so once that is done I will see if thats the problem.
Roland XC540 Sheet Set Error
Ok everyone I am baffled.
Ive recently had the head board repaired and replaced one of the print heads. I replaced all the parts and fired up the machine to do testing and calibration. I then loaded my material and got an error message:
Sheet Set Error
After...
Good day ladies and gents!
I have a Roland XC-540 Prolll and am experiencing an issue. I just replaced my head board and black print head. Install went good, machine turned on no problem. I needed to do a few test prints and calibrations as I mentioned I replaced a print head. But when I...
Previous Encounter
Hey Robert, thank you for your input. You mentioned sending in many boards. Out of all the boards and referrals have you had any success? what happened with him stiffing you $700 if you dont mind me asking.
Im trying to be patient - he mentioned he was off last week but that was last week. Ive thought he might be inundated with work and I can appreciate that. But Ive been emailing him since Monday, a simple reply back saying hes working on it would be appreciated. But heres the kicker!! I had my...
has anyone used MacMedia to get replacement parts or have a head board fixed only to get absolutely no response after payment has been taken??
Ive sent a head board in about 2 weeks ago, I received a notice that the part shipped has been received and would look at in a day or so. A couple days...
Not taken as stupid by all means. I know sometimes its the simple steps that get over looked. Yes both cartridges have ink and dampers are full - There was a degrade in print quality on the test patterns till there was no pattern once the board fried :( -- it was at the point I was inspecting...
Thank you guys for your input - Desert Signs Im not dicking around with the fuses - I took your advice and contacted Mac Media... Its funny you had mentioned that company as I found them online last night but wasnt too sure about sending the part. Ive seen a few people mention them so I went...
Im going to try and not be so wordy but very descriptive:
I have an XC540 ProIII - My problem started when running a test pattern. The Black head was missing a full side, I ran a few medium cleans and no luck getting the head to fire. I dismantled the machine to check the dampers and the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.