Search results

Thank you, I did remove the large capacity ink tanks in the diagnostic menu, but then I did not have a new set of 775ml tanks to replace with, so I had to revert to normal again. I assume just putting in a whole set of new 775ml will allow us to continue printer after the 3.0l are uninstalled?

We are having an issue with our Seal 62 plus Laminator not lowering to 0mm setting for laminating vinyl print media. We can get it to 3mm, but anything lower and the roller retreats to the max setting. We tried moving the receiver laser sensor, left, right, up, down, and adjusting the mode, also...

Hello, I am running into an issue with our 570. Firstly, the prints are pulling optimizer ink only from the intermediate tank, and not the 3.0L Tank. Both ink tanks were replaced and the problem has continued, they are under warranty, or were not too long ago. There are no leaks behind either...

My inks are expired, and I did replace the yellow, in both ink tanks, re ran color calibration, and still my images looked washed out, and the yellow seems undersaturated. If I add a Mulitply 35% of pure yellow over the image, the color looks accurate. I have never shaken the ink boxes, but...

1) I cleaned the printheads tonight, same issues; The printer info just says to check the warranty note. 2) Yes, not a lot of printing. i will not buy the 1.5L refill tanks next time. 3) The Media Color calibration is up to date.

Hello, looking for some suggestions. I seem to be having some color consistency degrading with Yellow / Magenta over time. Item in the front is probably 1 year in age, then the middle is 2 months old, than the back print is from today The Optimize Print Quality maintenance ran successfully...