• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Summa Opos Cam & Flexi 19

    Hi everyone, I am wondering if there is anywhere I can look on how to properly use this machine. I am coming from a printing on a Mutoh using Flexi Mutoh, cutting on a Graphtec fc8600 to now using the Mutoh, Flexi 19 and the S2TC160, and am having trouble trying to figure out how to get it to...
  3.

    1638X Streaking?

    Hey everyone, Currently I'm having an issue with the 1638X leaving red streaks in the prints. At first it was doing that and also leaving super tiny red dots also. Since I read up something could be clogged, I printed a giant red rectangle, and that took care of the dots for the most part...

  4. Graphtech Error E03002

    Hi everyone, Hoping someone can point me in the right direction. I've owned a FC8600-160 for the last 5 years. It has been acting up recently. Between the 3 programs I use (Flexi, Xpel DAP, TruCut), it is sending Error E03002 (HP-GL ERROR INCORRECT PARAMETER #, SET BOTH CUTTER & SOFTWARE TO...

  5. Summa Software?

    Hi everyone, Looking to replace my Graphtec with a Summa, however I'm not sure what to use for software. Currently we have Flexi, Mutoh Edition which only allows to cut with Graphtec. Currently we cut basic cut decals, and occasioanlly contour cut what we print on the Mutoh. I am swapping...

  6. Suggestions What plotter is best?

    Hi everyone, I am hoping someone can give me feedback/point me in the right direction. I am in the market for a new plotter. My Jaguar IV finally died. I mainly used it for window tint and vinyl decals. I plan on moving my Graphtec FC8600 to my tint shop to take its place. to handle that and...

  7. FC8600 Contour Cut Off

    Hello, Been searching and trying to fix this problem for days. Hopefully someone can help that has faced similar. I use a Mutoh to print, Graphtec FC8600 as a cutter, run by Flexisign & Print Editor Mutoh Edition. Contour cut is seriously misalinged. Tried to cut a set of lettering...

  8. Perform CR Maintenance

    Hello, New to the forums, but have lurked a while. I recently purchased an aftermarket ink setup for my Mutoh 1638X from a vendor (believe they are on here, so won't name as of yet). One of the cartridges came defective, and caused a whole bunch of ink (cyan for placement as to where it is on...
Top