• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1.

    Overcut in Summa Cutter Control

    So i just got this strange effect: When i cut on my Summa S2 T 140 through Summa Winplot everything is just perfect. But when i use Summa Cutter Control for i-cutting it "overcuts"? (not sure what to call it) These letters are 7 mm high (0.27 inches) I have no clue as to where to start looking...

  3. Oil for Carriage Rod?

    Edited to delete because i was misinformed by the supplier
  4.

    HP 310 with Cyan problems

    I "inherited" a HP 310, and have not had any introduction to it, so i'm learning as problems show up. This time its the Cyan that's acting up. When i print blue misses about half an inch. Then it gets going. After a headclean and automatic alignment i get this result. Is there anyone who can...

  5. Blue turns purple during drying

    Hi. I have a HP310 and a problem. As i print a blue logo it looks all blue and correct just after the printhead, but when it comes out of the heater it's purple? I'm new to this printer and have no idea where to start troubleshooting. I print on Oracal 5600 reflective.
  6.

    S2 140T not cutting right with SCC

    Hi. new member, first post. I have a Summa S2 140T and run it with Summa Winplot and Cutter Control. When i cut with winplot everything is as it should be: perfect results. But when i cut printed files with SCC it "overcuts". Like, for instance, when it cuts a small "i" the cut continues...
Top