• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. HP Scitex FB700

    Update: Technicians thought they had it figured, installed the components and the machine booted up until this message. HP feedback then said we need firmware v4.07

  3. HP Scitex FB700

    I replace the IO board and the machine booted to 38% but no further. We’ve looked after it for 12 years now so the motherboard replacement is more of an upgrade as well from the old green Intel to the blue Advansus. This cancels out the possibility of using the old HDD because the Advansus...

  4. HP Scitex FB700

    I suspect it happened because of intermittent blackouts

  5. HP Scitex FB700

    Thank you for your response. The service manual doesn’t state anything about the parameters being pulled, etc.‍♂️ Do you perhaps know where I could read more on this? All my research had done is help me learn that we now need a separate on/off controller for the new motherboard ‍♂️

  6. HP Scitex FB700

    Hi All, Just a question. We've had a problem with our HP FB700 and it turned out that the software component on the IO Board was fried. We replaced the IO board and the machine still didn't boot. We then purchased a new motherboard and HDD for the machine but I've been told that I cannot...

  7. Finecut Connection issue

    Hi all, I have the same issue: CG-130FX plotter, upgraded to a Windows 10 machine, loaded all the latest drivers and upgraded firmware and software to Finecut 9 on Coreldraw21. I can cut if I send to the CG-FX Series as a printer using usb but as soon as I try using Finecut I get the "No...
Top