Search results

I noticed some horizontal banding in my prints. Referred to the manual which said to perform a cleaning depending on the severity of dot displacement. This fixed the dot displacement in the test prints but I noticed there was no yellow. Instead the yellow was solid black. A few more test prints...

I think I may have figured out the problem. I thought the initial test the tech performed was for general printing and cutting. That seems to be different and the manual shows a test for calibrating crop marks. Currently fixing it and will need to print out a test to see if it is fixed.

I've used different media and had the same issue. I've also tried different cut settings with no luck. I just checked the sheet the tech worker used as well as looked at the manual and it seems they did the right alignment test that the manual says I should try when there's a cutting crop mark...

What do you mean by RIP? I'm not changing any settings after the initial print. It's the exact same file and settings except flipping from Print Only to Cut Only.

I'm trying to start incorporate laminate into my decals. Until now I've just been printing then cutting. With the laminating I have to use the crop marks but they aren't cutting properly. They are off by a noticeable amount. I did some testing and so far I came up with some points. 1: The...