Search results

I currently use a Gerber Edge FX film printer, Ledco Laminator and Gerber en Vision plotter to produce helmet decals. The process is time consuming, expensive to buy films, limited to film colors and I can only use the Gerber to cut what has been printed on the tractor fed vinyl. I need help...

It's a 20" circle. The router did a much better job accept for the points of the grass and the stars. I may try a combination of knife for grass and stars and router for other pieces after masking. I also have a double sided medium tack 18" adhesive roll that I'll attach to a sheet of MDF. My...

I need help getting the white to cut out of this. I'm trying to cut a stencil out of .040 styrene on a Colex Sharpcut. I have tried the double edge blade, 80 degree (didn't cut small letters well or thin lines) and I have tried a 3mm router bit (Small pieces got caught in the router and caused...

I know I'm a little late but please be sure to properly ventilate and use a mask. I ended up in the ER from breathing the vapors of AP3155. Super dizzy, nausea and stroke level blood pressure.

I am using a spiral upcut bit. I continue to have the ink chip when cut through but I was worried about overspray when it comes to cutting then printing. I will have holes for standoffs and want to avoid the ink getting on the sidewalls of the final product and the sidewalls of the standoff...

I'm printing a 100% coverage job @ 72"x46" on a full sheet of acrylic with white behind the entire print and 1/8" bleed. The print is on a Vanguard VK300D with max passes of white and I'm using Adhesive Promoter. I need to cut out the final product with square corners and holes for standoffs...

That sounds like a great solution. Cheap, durable and a consistent thickness across the board is exactly what I was looking for. I feel like you could get quite a few uses out of that one sheet too even if you had to lightly sand it every once in a while to knock the fuzz off.

I am currently using a Colex Sharpcut to cut 3" circles, 3"x6" rectangles, etc. from 1/4" acrylic 4'x8' sheets. Sometimes I only cut into and not all the way through to make a track. I am having problems with the small pieces moving and either cutting the wrong shape or leaving a little...