• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

#dibond

  1.

    Need Help How to Attach Dibond Signs to Existing Protruding Metal Bar

    Hi I’m a total newbie, in England I’ve taken over an abandoned premises and took down their rotten wood hanging sign - I’ve ordered 2 x (850mm x 750mm) Dibond 4mm deep signs with 4 drill holes (5mm I think) at top and 2 in bottom corners. Could anyone tell me please how to securely hang them...

  2. ACM Panels - Ink Adhesion Primer Suggestions?

    Hello! We are printing ACM Panels on a Flat Bed EFI Vutek then laminating with them a satin laminate. We are allowing them to breathe for about 48 hours before laminating, yet after laminating if you pick at the corner the laminate and the entire print comes off. We have had success when...
  3.

    Need Help Need help please.Best adhesive for mounting acrylic backer to routed ACM panel for exterior lit sign

    Hello everyone, We have had a failure with this sign. The acrylic white backer separated from the DiBond panels in areas. We used tape (not VHB) and silicone adhesive to mount the acrylic to back of ACM panels. The two acrylic panels per side were 4’x4’ for top panel logo and 2’ x 7’ for...
Top