• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

e01019

  1. Crosscut function crashes and displays error E01019

    I've been using the Graphtec FC9000 for a couple of months without issue until yesterday, when it started having a problem. When performing a crosscut, most of the operation works fine- it cuts the paper, but then it performs some calibration it seems, and the carriage intersects with a pin on...
    • Goooost
    • Thread
    • crosscut e01019 fc9000 graphtec
    • Replies: 6
    • Forum: Graphtec

  2. Need Help Graphtec FC8600-130 error E01019 wont move left

    When initializing the machine will go to the right and Beeps and errors out. Nothing more. Only goes right. Called maintenance they say the motor is out? what about a limit switch? Waiting for a motor but want to make sure no one else has had this issue and it be more than that. Also If you...
    • AHornback
    • Thread
    • e01019 error graphtec 8600
    • Replies: 4
    • Forum: Graphtec

  3. Need Help Graphtec FC-8000-130 error E01019

    I need some help. I've had this plotter for several years without any problems. I tried to plot with it and it asks for type of media (ie:Roll, sheet) so I pick either one and the blade carriage moves slowly to the far left then hits the end and gives me "ERROR E01019" message. I've installed...
Top