• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

reference point

  1. Zund reference point not accurate

    Hello all, I have a really frustrating issue, the zund won't cut to the reference point I set, I think its because its not using the laser as the point, its using the tool, I found where to switch that over via the zund manual but for some reason I get to the final steps and the manual doesn't...

  2. ZUND won't cut on Reference point

    Hey everyone, I have never had this issue before but I've been clearing and changing the alignment to 0 before setting any reference points, then I'll manually enter it through the Zund panel, but it still cuts off of the reference point each time, I even do a laser simulation to check its...
Top