spray

Didn't know exactly where to put this. We are looking to add a paint booth to our shop. Trying to find the best option for us. Looking for a smaller booth. Possible about 10x8. I'm looking for different options. The shop is used for a lot of mixed uses and cars are sometimes kept inside so...

My Mutoh VJ-1324 had clogged nozzles and wasn't printing anything. I soaked the head and pulled ink through the dampers and had about 98% of the nozzles working perfectly. 1 day later I went to print and it was off-color. After doing a nozzle check I found Cyan & Yellow were at 100%, Black...

Hello again, I'm experiencing another printing problem with our Roland Soljet Pro III 540. I'll have images attached here below: The media I'm using is Scotchcal film, high gloss, with air release. I can't remember the number, sorry! Anyway, these purple, dust-like sprays are more...

Hi everyone, I have a z2100 that I use for indoor prints, and I read that another member has used it for some short term outdoor signage. I thought about printing a few signs and then coating them with some UV spray laminate, does anyone here have any experience with this, and does anyone know...

I am very used to automotive paint for all my signs fabricated in house. Recently people have been telling me to just spray paint, if it is not an exact pantone I'm trying to match. What is everyones thoughts, experiences, etc...uses? (exterior vs. interior)

Toy drum with Oracal 651 and fade created with Krylon spray paint in a can. The effect was created by spraying over the edge of a peice of cardboard about 8" above surface. Prior to spraying, I outlined the cuts with a blue Stabilo pencil so I knew where the graphic was on the vinyl film...