• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Colex and alumacorr

M

michsanford

New Member
Hi! We have a Colex Sharpcut, and need to cut some 10mm Alumacorr. I am not sure which bit to use. Any suggestions?
 
Last edited:
fuzzy_cam

fuzzy_cam

The Granbury Wrap & Sign Guy
We use an 1/8" straight-flute endmill on 3MM ACM. You might have to step up to a .25" to have the cutting depth you'll need.
 
S

SharpCut

New Member
We use 4mm oflute upcut for direct print, downcut for overlay (or back cutting with upcut). We've found narrow bits give us the best compromise between speed and quality.
 
You must log in or register to reply here.
Top