Corrugated panel widths

[stew1tx]

Anyone have any good measurements for corrugated widths? Not coverage width but what it would take to cover a given width. IE: if a given panel of r panel corrugated is 36” laying a piece of vinyl to get full coverage would be something lol 42” after the valleys eat up extra vinyl.

Thanks in advance

Brian

 

[OhioSigns]

If you have the corrugated metal to measure just run a piece of tape down it going into the valleys. Mark / cut the ends then lay it out on a flat surface and measure. ..... This would be the most accurate way of measuring.

 

[stew1tx]

Ya I’m on road and don’t have a piece. Many different styles of panel to boot

 

[signage]

Ya I’m on road and don’t have a piece. Many different styles of panel to boot

Then how would you expect someone to be able to give you a length? 2nd post answered best solution, painters tape is widely available and not expensive