Gerber Envision 750-Problem

[aamaska]

Hello all,

I have been searching the topics here to see if someone else has a similar problem with their plotter. But I didnt see any. The cut seems to be off a bit when cutting, see attached picture. If you look at the C, its not perfect. Any sugestions? I cleaned the machine really good, and didnt notice any problems.
Thanks

 

[Tony Teveris]

I believe the cutter has some built in cut test (XOX) comes to mind.

Dig down through the menu on the cutter.

Also, try to slow the cutter down, way down to see if it makes a diff.

 

[aamaska]

I found this test I will run this later today, and let you know. Thanks for the help.