bendeane
New Member
I just got a roll of PanoStar Non-Adhesive Perf Vinyl that you put PanoStick adhesive over the top of the image to adhere it to the inside of a window (Interior Window Perf). The roll of vinyl has the backing any perforated/mesh banner material would have, but this stuff is bubbling up from its backer like crazy. I can't print on it 'cause my ramps hit it in the areas where it is not flat against the backing. Anybody else having this problem? It recommends not heating about 106 F and I've adjusted my printer accordingly. Any suggestions???
Thanks,
Ben
Thanks,
Ben