Mimaki cjv 150 not cutting

[Lighthouse Promotion]

It was hit and miss whether our printer/cutter would cut. Yesterday, wouldn't cut at all, would start locating, rendering and then just quit. Updated all software, reinstalled updated to Rasterlink 6+ and fine cut 9, did one print/cut, worked perfectly, then would only print and not cut. Any help is appreciated.

 

[Notarealsignguy]

Try putting a piece of tape over the media sensor. Your sheet is probably curling up and making it read as if there's no media.

 

[Lighthouse Promotion]

Got it figured our. Reinstalled rasterlink and didn't check off convert spot color to CMYK. Simple fix after frustratring day