I recently reset my Graphtec fc9000 due an issue with the carriage.
I now can’t remember how I connected it to my onyx.
I set the cutter to use auto instead of hp-gl and gp-gl but that didn’t work. I’m sure I set this up like this before as I used both cutting master and onyx.
I also tried to set it to hp-gl and that still didn’t work. I’m setting this up using the IP address and when I test it, I get the green light to confirm it’s correct but when I send the file nothing happens on the Graphtec.
Anyone know what I am doing wrong or not doing?
Thanks
I now can’t remember how I connected it to my onyx.
I set the cutter to use auto instead of hp-gl and gp-gl but that didn’t work. I’m sure I set this up like this before as I used both cutting master and onyx.
I also tried to set it to hp-gl and that still didn’t work. I’m setting this up using the IP address and when I test it, I get the green light to confirm it’s correct but when I send the file nothing happens on the Graphtec.
Anyone know what I am doing wrong or not doing?
Thanks