• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Polypropylene Printing

A

Aaron Mercer

New Member
I am trying to print on 0.6 mm thick PP on a Roland VS-640 and I'm not sure where to start. There is not any documents for something so thick. Is it even possible to print on this material with this printer?

Any advise would help.
 
S

SignMeUpGraphics

Super Active Member
Is that anything like the old V-POP media line?
If so, we had limited success printing on it due to the fact that we couldn't get enough heat into it to take ink without huge dot gain, then too much heat would cause the PP to buckle and cause head strikes.
After than one job, we never printed on it again until we got our UV flatbed.
 
You must log in or register to reply here.
Top