• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

registering to back at start up

signgal01

New Member
I have a graphtect fC7000-75 that is a workhorse! I have had this problem twice and can't remember how to fix it. When I start up the machine and select roll1 to get the machine registered to the front right to start cutting it goes to the back of my roll and stops on the left side. I feel like it is just pushing the right buttons to fix it but can't remember.

Vicki Sign Gal
 

Joe House

New Member
When you load your media, you've accidentally set it to "Front Set" It happens all the time with that model. It's been too long since I've run one of those. Look before you lower the pinch wheels or right after. You should have the option to change that. I believe it was using the uip and down arrows to change from Front to Rear.

Good Luck
 
Top