Hi,
Is there a way to automatically rewind the media after an automatic sheet cut?
After the cut, the flex remains in position 1, but I would like it to return to position 2 (see attached photos).
At the moment, this causes approximately 10 cm of material to be wasted after each cut.
Thank you for your help.
Stéphane
Is there a way to automatically rewind the media after an automatic sheet cut?
After the cut, the flex remains in position 1, but I would like it to return to position 2 (see attached photos).
At the moment, this causes approximately 10 cm of material to be wasted after each cut.
Thank you for your help.
Stéphane
