• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Scan and Feed adjustment under MENU

anozira02

anozira02

New Member
I am a bit puzzled,,, in MENU mode (not service menu) going to Calibrate,, there is Print and Cut adjustment for Scan and Feed adjustment but
it is by percentage instead of millimeters like everywhere else is for Scan and Feed settings,,, What number should be entered in there, or is it
important at all?
 
You must log in or register to reply here.
Top