• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Summa D-140 (Failed to enter) error when turning on

Chosen23

Chosen23

One man shop
Just today this started, The plotter jammed up vinyl on a cut. When I turned it back on I get ENTER AT FAILED error. when you push enter it seems like its fine, however when you send a job it never actually shows up at the plotter. Please if you have any suggestions I would greatly appreciate it.
 
Last edited:
G

geNe36

Just Sharing
This message appears on a SummaCut with network interface (SummaCut RL).

Make sure only one communication cable is connected to the machine (either USB or Network - NOT both).

Also try to set the IP address in the router for the cutter to a static address, use the same address in the cutter.


In this case above doesn't help than most likely the mainboard will need to be replaced.
 
You must log in or register to reply here.
Top