Trying to cut lines over 75 in......

[selfser]

But after it reaches the end of the panel, it cuts the line and then begins to finish the rest of the cut leaving me with 2 lines instead of 1 straight through line.

I decal have from some vehicles and some of the decals that I have will cut into both panels without cutting through my design. Now the straight line that I try to cut keeps getting cut through it and leave me with 2 lines instead of one. I am using flexisign 8.1. and have a 15 inch roland vinyl cutter.

Could it be something that I can do when sizing my lines to avoid the cut through or would this be a setting that I would have to change when I am about to cut? I am new to this, making my own designs, and love this software and cutter

Any help or suggestions greatly appreciated.

 

[stoliker]

check for panel sizing in the software. I run into this with a mimaki out of cocut, will only cut so long before it tries to be helpful and automaticly panel it.

 

[Mainframe]

Sometimes if you click "poll size" it helps also, it is in the production manager

 

[Gino]

Welcome from PA............................

 

[selfser]

check for panel sizing in the software. I run into this with a mimaki out of cocut, will only cut so long before it tries to be helpful and automaticly panel it.

I tried this and it keeps cutting a line right through again. I set it for 2 tiles on the PANEL tab. checked overlap and unchecked overlap and still the damn thing keeps cutting through at the end of the cut.

@Mainframe

I can't seem to find the poll size in the production manager.

I have somethings that I are long and get cut divided into 2 tiles that cut fine without cutting through my lines. Mind you, these are files that were prepared for me so maybe the person that designed them did so in a way that the lines stay intact, even when tiles and over 40 inches.

Could this problem be on how I created the "lines" over 40 in?

 

[selfser]

Welcome from PA............................

Thanks for the welcome!!