Hello all,
Question when tiling large prints. When I print and go to install the seam has to be dead on. There is no overlap. If I chose overlap in the clip and tile tab it has 2 choices. All corners and top left. Would one of these options allow me to overlap the print a bit so its not butted up to one another and I dont have to worry about leaving a gap and the background showing through?
I know I could just print some test stuff to try it but its cheaper and easier to ask the experts on here. Thanks in advance.
Question when tiling large prints. When I print and go to install the seam has to be dead on. There is no overlap. If I chose overlap in the clip and tile tab it has 2 choices. All corners and top left. Would one of these options allow me to overlap the print a bit so its not butted up to one another and I dont have to worry about leaving a gap and the background showing through?
I know I could just print some test stuff to try it but its cheaper and easier to ask the experts on here. Thanks in advance.