SoonerGlue
New Member
I have been using my Roland VG2-540 printer for quite sometime and have pretty good experience with it. The GR2-540 is brand new and I have no experience using a plotter. I have resourced all of the YouTube videos but there was surprisingly little on it.
It's connected through Versaworks. I believe I know how to add the crop marks via cutworks and make it a print only.
1) Do I have to use Versaworks Dual to drag the print over from the VG2-540 to the GR2-540?
Either way- any helpful tips on how to proceed once you have the media loaded with the crop marks lined up with the blade.
Any tips on the plotter would be awesome!
Ty in advance.
It's connected through Versaworks. I believe I know how to add the crop marks via cutworks and make it a print only.
1) Do I have to use Versaworks Dual to drag the print over from the VG2-540 to the GR2-540?
Either way- any helpful tips on how to proceed once you have the media loaded with the crop marks lined up with the blade.
Any tips on the plotter would be awesome!
Ty in advance.