"(x OVER current:AVE.) Press<ENT>" mesg.

[WestbankKurt]

My mimaki has stopped twice during a print this morning and I get this message "(x OVER current:AVE.) Press<ENT>". Does anyone have any idea what this means? I consulted the manual and it suggested unplugging and trying again and then calling the tech. I have sent the tech an email so now I am asking fellow Signs 101 readers to help me.

Thank you

 

[woahdude]

ive gotten this when i turn off the pickup roll and at the end of a print the printer back feeds and theres not enough slack. maybe you have too much tension on the pickup roll?

 

[ironchef]

Where do u change that option

 

[Masseria]

on the pickup, roll...
If you have a Jv33, in user manual page. 45/198 manual.

here's a picture:
http://subefotos.com/ver/?e191b424b4dd72478321b3f3b4b4a28do.jpg

hope thats the problem.

Warning: too much torque, and strechy media, will make banding....

 

[woahdude]

on jv5 its on right side of pickup roll, the white knob

 

[ironchef]

Oh. I knew that. Lol sorry. I only used the take up reel once