Recent content by Pinhole

I have not, I'll look into it, thank you!

So, I guess no one is using an Apple M1 to run a cutter? I am trying to limit the amount of equipment I need to add, and to use what I currently have.

Hi all, I am sure this has been discussed before, but I haven't been able to find a straight forward answer and don't have hours to dig through forums. I am looking at adding an entry level vinyl cutter to my shop, mainly for cut-vinyl decals. I am running a Mac with an M1 chip with Ventura 13.6...

This, too, was a concern of mine. Wondered about a table top with some form of shock absorption. I did plan on HVAC in the trailer for trying to minimize climate swings.

Good point in regards to getting the photos off a phone. Thanks for the input. The booze under the desk is always a possibility! If anyone else has any experience with similar business, please chime in!

I definitely see what you are saying in regards to decals. I am thinking of offering photos on framed canvas. A limited number of sizes and treatments done to said canvas. Basically, bring me a photo on your phone and leave the event with a personalized piece. Not exactly a sign per se, but the...

I just read this thread and wanted to follow up with the OP and see which route they went. I too have a similar idea, but was planning on tailoring it to craft shows, fairs, and swap meets offering a limited selection of products that will be custom ordered and produced on-site.