Hello! I've been wondering lately about a certain type of sticker I'm looking to offer to customers. When I do pop-out stickers, I usually set a border of about 1/4" for the perf cut, then the normal kiss cut. This leaves a 1/4" of scrap to weed, and leaves a white liner border on the finished product. While this looks fine, I've been wondering if there's a way to do a pop-out around the actual shape of what would be the kiss cut?
In other words, can I go full depth around the shape of the kiss cut so it pops out, and have it cut through cleanly? I haven't tried it yet, but if I made the kiss cut a perf cut instead, it won't leave a very clean edge around the final sticker itself.
Graphtec FC8600 and Flexi, by the way.
Any ideas?
Thanks!
In other words, can I go full depth around the shape of the kiss cut so it pops out, and have it cut through cleanly? I haven't tried it yet, but if I made the kiss cut a perf cut instead, it won't leave a very clean edge around the final sticker itself.
Graphtec FC8600 and Flexi, by the way.
Any ideas?
Thanks!