I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I had to set my adhesive vinyl (6mill) to 2.0. I was told by all techs 1.6 was fine for all adhesive vinyl but it was causing head strikes, bad color etc.
That's fine then.. if your media is buckling you can either reduce the heater temperatures, or increase head height. I prefer to lower the temps a little as the GS3 inks seem to perform nearly equally as good without the heaters even being turned on.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.